I have another option for you, but since the frame on your trailer is 8" tall you will not be able to use an Equal-i-zer weight distribution hitch like the Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 12,000 lbs GTW, 1,200 lbs TW # EQ37120ET as it can only accommodate frames up to 6" tall.
Instead I recommend the Reese Weight Distribution w/out Shank - Trunnion Bar - 12,000 lbs GTW, 1,200 lbs TW # RP66022 with the Chain Hangers for Reese Weight Distribution Systems... view full answer...
If the Ford E-450 cutaway chassis your Class C is built on has a factory 7-way trailer connector it should also have a connection port for a trailer brake controller. You should find this behind the small dash panel shown in the linked photo. The brake controller harness you referenced, part # 3034-P, will work for any Tekonsha or Draw-Tite trailer brake controller, including popular options like the Prodigy P3 # 90195, the P2 # 90885 and the Primus IQ # TK90160.
If it turns out your 7-way... view full answer...
As long as your 2015 Thor Axis (which was built on the Ford E-350 or E-450 chassis) features a factory 4-Way or 7-Way connector at the rear then there will be a factory port behind the dash that will connect to the Plug-In Adapter # 3034-P. This port is specifically located behind the access panel in the center of the dash. You will need to carefully pry this panel out and undo the locking tabs that are keeping it in place. The mating connector to the Wiring Adapter will be behind this... view full answer...
The correct WeatherTech Side Window Air Deflectors for a motorhome on a Ford E-Series Chassis from 2015- 2020 is part # WT80031. The WeatherTech Side Window Air Deflectors install inside the window channel so there is no tape required which I think is what you are looking for. That said, this method of installation is the only option for a Ford E-Series Chassis. view full answer...
The reason there are two 1-1/2 inch diameter Roadmaster sway bars that fit your 2017 Ford E-350 is that the # RM-1139-198 is for versions of the vehicle that have automatic snow chains that deploy and the part # RM-1139-117 is for the versions that do not have the chains. So based on whether you have the snow chains is how you'd pick which set to go with! view full answer...
To use the Roadmaster Spare Tire Carrier # RM-195125 with your 2020 Ford E-350 Class C spare tire you can use a wheel spacer mounted to the carrier to allow the wheel to fit on the mount with the tire reversed on the carrier. I have seen that the mount has been used with the dual tire mounted with the hub face toward the vehicle.
On the Roadmaster Hitch Mounted Spare Tire Carrier # RM-195225 you can use a Roadmaster High-Low Adapter # RM-048-4 to raise the carrier higher to achieve the... view full answer...
For your 2021 Thor Axis motorhome built on a Ford E-350 chassis, there are a couple of SumoSprings that fit, both rear springs and front springs:
- Rear: SumoSprings Maxim Custom Helper Springs # SSR-106-47-1
- SumoSprings Solo Custom Helper Springs # SSF-106-47
These springs work independently which allows your motorhome to reduce the amount of body roll you experience when making a turn or getting caught in crosswinds. It will help you stay level and give you more control when driving... view full answer...
I recommend the Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle, #F22ZR. These have 5,000-lb Capacity. Ride-Rite air springs enhance your factory suspension for safety and stability when you are hauling heavy loads. They reduce strain on your rear axle, keeping your Ford E-Series Cutaway level. While they do not raise your vehicle in any significant way above factory, they eliminate the sag caused by the weight. The air bags can be adjusted manually, side to side,... view full answer...
Yes, the Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket # PK12-707E matches up with the 7-Way plug that comes with the Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord # BX88206. view full answer...
The SumoSprings kit part # TGMRC20 that fits your 2018 Ford E-450 will lift the rear of the RV about an inch so it would be the option you are looking for. view full answer...
I have a couple options for you as the Curt High-Low Adapter 45797 # C27KR is only designed to be used with tow bars when flat towing. The Curt Class III Ball Mount with 2-5/16" Ball # C45065 is only 9-1/4" long from the receiver hitch pin hole to the ball mount hole.
The Curt Ball Mount # D-28 also has a 6" drop like the other Curt ball mount but this mount is 14-1/4" long from the receiver pin to ball mount hole. That would gain you 5 inches without using an adapter. The ball mount... view full answer...
We do have kits that are designed to convert a standard RV awning to a smart awning but they include new arms and heads since that's the easiest and best way to make the change. We have 69 inch and 63 inch options available in black and white. In the 69 inch arm length we have the black # LC759517 or white # LC759405. For 63 inch we have the part # LC759516 for black or # LC759404.
You wouldn't have to buy new awning fabric though as you can reuse what you have now with any of the mentioned... view full answer...
We do have an option to upgrade the support for the rear suspension on your 2021 Ford E-450 cutaway chassis, and the best option that will fit are SumoSprings:
- SumoSprings Maxim Custom Helper Springs # SSR-106-47-1
The # SSR-106-47-1 have a 5,000 lb capacity and are going to improve the stability and handling of your E450. The reason for that is they engage as needed, and compress based on the amount of weight being transferred. So when you have a load in the cargo area, or when you... view full answer...
We do have one solution we can provide. None of the hitch bike racks we offer for E-bikes are rated for use behind RVs/trailers, but the Ultra Fab motorcycle carrier part # UF48-979033 is a motorcycle carrier which is rated for use behind RVs so it would be a great option although a bit overrated. view full answer...
For your 2015 RV built on a Ford E-450 cutaway chassis the best rear sway bar we offer is the part # RM-1139-147 which is a confirmed fit. The rear sway bars are the suspension modification that makes the best improvement in ride quality so I know this will work very well for you.
To see the install process check out the install video I attached.
A 17/32 inch size hole will need to be drilled.
The torque specs are listed in the 7th step of the instructions that are attached in a link... view full answer...
Yes, the CIPA Universal Towing Mirrors # CM11980-2 will indeed work on your 2022 Ford E-350. These mirrors are highly adjustable and can be made to fit virtually any factory side view mirror. You would be hard pressed to find a mirror they would not fit on. The telescoping design is a great feature and will give you good visibility, even with larger, longer motorhomes.
I have linked our review/install video below if you want to take a look. view full answer...
I attached a link to a page that has all of the bike racks we offer that are rated for the rougher ride quality found at the rear of flat towed vehicles like your motorhome and Grand Cherokee. One of our more popular options is the Yakima Holdup platform rack # Y02443 which is a platform rack that only touches the bikes by the tires.
Or for a hanging bike rack the Yakima Ridgeback part # Y02458 would be a great option as well. view full answer...
If your power awning is a Solera powered awning the replacement cap part # LC423751 that you referenced would be correct for it. If you have a different brand though this most likely isn't what you'd need. view full answer...
The SumoSprings Custom Helper Springs that I recommend for your 2017 Thor Motorhome 22FE is part # SSF-106-47 for the front and part # SSR-106-47-1 for the rear. The SumoSprings Custom Helper Springs will absolutely help with sway as well as porpoising. There is also another option for you to help control sway as well, the Roadmaster Rear Anti-Sway Bar part # RM-1139-117. These are the two most common upgrades on a motorhome to help with sway and other stability issues.
In regards to trailer... view full answer...
The Wheel Masters Airless 2-Hose Inflation Kit WM80092 you mentioned is designed for 16" wheels while the Wheel Masters 2-Hose Inflation Kit # WM8005 is for 22-1/2" wheels so the 80092 would be my recommendation if it wasn't a discontinued kit.
Because of this I recommend checking out the Wheel Masters 2-Hose Inflation Kit # WM8002 which has the same type of design as the first two kits you were looking at.
I'm also linking our selection of hose inflation kits that work with your 16"... view full answer...
Go To Results